Singer 1200-1 - Page 31

56
57
To Make a Ruffle and Sew it to a
Garment in One Operation
Insert the material to be ruffled between the two
blue blades, as shown in Fig. 60, following the line
FIG. GO
2, in Fig. 58. Place the garment to which the
ruffle is to be attached, under the separator blade,
following the line 1, in Fig. 5S. Proceed the same
as for gathering.
The edge of the ruffled seam can be bound by
using the binder.
To Ruffle and Sew on a Facing
in One Operation
Insert the material to be ruffled between the two
blue blades, following the line 2, in Fig. 58. Plaee
the garment to which the ruffle is to be attached
under the separator blade, following the line 1, in
Fig. 58. Place the material for the facing over the
upper blue blade, as shown in Fig. 01, following
the line 3, in Fig. 58. The facing may be straight
or bias material. If the facing is to be on the
right side of the garment, place the garment and
the ruffle so that the wrong sides are together. If
the facing is to be on the wrong side, place the right
sides of the gannent and the ruffle together.
Piping a Ruffle
Insert the material to be ruffled between the two
blue blades, following the line 2, in Fig. 58. This
FIG. 62
material must not be over 1 ]/i inches wide, as
it is carried through the ruffler with the finished