How to troubleshoot no output signal on Sintrol S300?
If your Sintrol Measuring Instruments have no output signal, first check that the power and signal wiring are correctly connected and that the device has power. Then, run the auto setup.
General| Power Supply | 24 VDC |
|---|---|
| Protection Rating | IP65 |
| Output | 4-20 mA |
| Operating Temperature | -20°C to +55°C |
| Application | Dust concentration monitoring in industrial processes |
Guidance on reading and storing the user manual for S303/S304 instruments.
Instructions for verifying the instrument and its package contents upon delivery.
Steps involved in the entire life cycle operation of the instrument.
Description and meaning of symbols and signal words used in the manual.
Details of the items included in the standard delivery package for S303/S304.
Information on available accessories and optional configurations for the instruments.
Visual representation and dimensional data of the S303 and S304 components.
How different dust materials affect the transmitted signal and measurement.
The range of particle sizes detectable and optimal for the S303/S304.
Understanding the measuring range, linearity, and calibration needs of the instruments.
Impact of moisture and condensation on measurement accuracy.
The effect of ambient temperature variations on the instrument's performance.
How gas flow velocity affects the measurement and compensation methods.
Considerations for measuring specific types of dusts, like heavy metals.
Guidelines for choosing the optimal location for sensor installation in ducts.
Step-by-step procedure for physically installing the sensor unit.
Ensuring proper grounding and power supply for safe and accurate operation.
How to connect the instrument to AC or DC power sources.
Wiring instructions for the instrument's dry-contact relays.
Procedure for connecting the instrument to a PC using a USB interface.
Details on connecting the analog 4-20 mA output for data transfer.
Information on establishing communication via the RS-485 serial interface.
Setting up a network of instruments using the RS485 bus.
How to connect a flow meter's mA output for flow compensation on S304.
Understanding the operational status indicated by relays, LEDs, and the display.
Detailed explanation of the automatic setup procedure for optimal performance.
How to navigate and use the instrument's display and 4-key interface.
Reference table detailing configurable parameters for local display settings.
Functions for resetting defaults and managing mg/m³ calibration.
Setting the integer part of the display intercept for mg/m³ calibration.
Setting the decimal part of the display intercept for mg/m³ calibration.
Setting the integer part of the display slope for mg/m³ calibration.
Setting the decimal part of the display slope for mg/m³ calibration.
Fine-tuning 20 mA scaling correlation with Inductive Electrification Unit (IEU).
Further tuning of 20 mA scaling correlation with IEU.
Read-only parameter displaying the instrument's firmware version.
Managing product parameters, Auto Setup, and Monitor view using DustTool software.
Steps to diagnose and resolve issues when the instrument provides no output signal.
Troubleshooting steps for when the instrument does not respond after auto setup.
Copy of the ISO 9001:2008 quality management system certification for Sintrol Oy.
Detailed mapping of registers for MODBUS RTU communication protocol.
Instructions for sorting and disposing of product packaging materials.
Guidelines for the proper disposal of S303/S304 instruments at end-of-life.
To Next Page
