Checklist of main steps
1. Remove chassis ground cable from car battery
2. Choose suitable place for the amp and mount it.
3. Install plus battery cable from battery to amplifier
4. Short ground cable from battery minus to chassis
5. Install all RCA cables with remote wire from radio to amplifier
6. Connect all cables to the amplifier
7. Reconnect minus (chassis ground) to battery.
8. Adjust as described
9. Have fun
Malfunction What to do
Power LED doesn`t light up check all fuses on the amplifier
check main fuse near the battery
check plus and minus battery cables
check remote voltage
Power LED is on but no sound check volume control on the radio
check GAIN regulator on the amplifier
check RCA cables and connections
check speaker cables and connections
Bass response is low one speaker cable could be misconnected
the bass regulator on the radio is set on low
an active crossover unit is adjusted wrong
The amplifier switches bad chassis ground connection to the
on and off amplifier
cable terminals and battery terminals are
oxidated
low voltage from the battery
remote wire is not connected right
If you cannot solve any of these problems please consult your dealer.
10
To Next Page
Loading...
