Siren R3+ - Page 8

8
Short press Volume button and the LED lights and
stays lit, ready to pair with further R3+ heads on the
same channel.
6. Once you have paired all the R3+ heads you require
press and hold the Power button for 3 seconds to
save the pairings and exit programming, signied by
a double beep.
Erasing programmed R3+ heads from the R3+
Receiver:
Short press of the Power button. This allows you to
check which alarm registered an indication even if you
missed the illuminated LED on the R3+ Receiver and
R3+ head. The LED that corresponds to the R3+ alarm
that last registered an indication will light and pulse for
ten seconds.
1. Press Power and Volume Buttons together, without
releasing. After 3 seconds the rst LED will light and a
beep will be heard.
2. Continue to keep both buttons depressed together for
a further 3 seconds, until three consecutive beeps are
heard and the LED turns off. This signies any existing
pairings with R3+ alarms have been erased. Note
individual heads cannot be selected and erased from
the R3+ receiver, all pairings have to be erased.
3. You can then go back into pairing mode by pressing
Power and Volume together until you hear a single
beep and the rst LED lights. Now pair your heads
accordingly.
NOTE: When in pairing mode, if no signal from an R3+ head
is registered within 10 seconds any new pairing information
will be lost, and the R3+ handset returns to normal operation
with previously saved R3+ alarm pairings.
R3 Plus Instruction Manual.indd 8R3 Plus Instruction Manual.indd 8 28/07/2022 08:5128/07/2022 08:51