Registered in England No. 08405712
VAT Registration No. GB163 04 0349
Siretta Ltd
Basingstoke Road
Spencers Wood
Reading
Berkshire RG7 1PW
sales
email
web
+44(0)118 976 9000
sales@siretta.com
www.siretta.com
27
SNYPER-LTE Graphyte
User Manual
Download Latest Edition
Rev 1.7
Figure 28. Selecting survey to perform
Performing a Multiple Cycle Survey
To perform a multiple survey on your SNYPER Graphyte, follow the steps below:
Step 1. Select ‘Survey’ from the main menu and press OK.
Step 2. Use the UP/DOWN buttons to select the type of survey to be performed and
press OK.
Full Survey: Performs a survey of the LTE, UMTS and GSM*
networks.
LTE Survey: Performs a survey for the LTE network only.
UMTS Survey: Performs a survey for the UMTS network only.
GSM Survey: Performs a survey for the GSM network only.*
* GSM surveys are only possible on the EU versions of the
SNYPER-Graphyte.
Step 3. Use the RIGHT button to select number of survey cycles and the DOWN and
then RIGHT buttons to select the survey interval (the time between the start of one
survey and the start of the next). The estimated time for completion will be shown at
the bottom of the display. Press OK to begin survey. For surveys that are expected to
take longer than 10 minutes to complete, the SNYPER-Graphyte will suggest that the
charger should be connected. If this message is displayed, then OK must be pressed
a second time to start the survey.
Figure 29. Selecting multiple survey options
Cycles: Pressing the RIGHT button increments the number of
cycles conducted in progressively larger steps. Up to 500 cycle
surveys may be conducted.
Time: Use the RIGHT button to increase the time interval in
minutes between each survey. Selecting zero (0) for the time
interval will perform back to back surveys.
A Multiple Cycle Survey can be interrupted by pressing the back
key for at least half a second. Any survey in progress will be
completed, so it may take several minutes to stop a multi-cycle
survey. If a logging survey is interrupted, any surveys completed
before the interruption will be saved and reported.
To Next Page
Loading...