SIRETTA SNYPER-LTE graphyte - Setup Menu

Registered in England No. 08405712
VAT Registration No. GB163 04 0349
Siretta Ltd
Basingstoke Road
Spencers Wood
Reading
Berkshire RG7 1PW
sales
email
web
+44(0)118 976 9000
sales@siretta.com
www.siretta.com
33
SNYPER-LTE Graphyte
User Manual
Download Latest Edition
Rev 1.7
By selecting ‘Setup’ from the main menu, the following setup changes can be made
(as shown below in gure 35). To select a sub menu use the UP/DOWN button until
relevant menu is highlighted, press OK and then use the LEFT/RIGHT buttons to
amend preference. Setup options are automatically saved.
Setup Menu
Figure 35. ‘Setup’ screen
Language: Language selection of your SNYPER Graphyte.
English, German, French, Italian, Spanish. Default = English
Display: Determines the brightness, body text and highlighted
text colour.
Brightness: 6 settings for display brightness. 0 (low) - 5 (high).
Body Text: 9 colour settings for body text.
Highlighted Text: 9 colour settings for highlighted text.
Disk Monitor: On or Off. When on, splits the battery capacity
bar in two and adds a pale yellow bar showing remaining disk
space
Default: Brightness = 5, B-Text = White, H-Text = Blue, Disk
Monitor = Off
Auto Off: Is a method of power saving for the SNYPER Graphyte.
It controls the automatic powering down of the unit if it has not
been used for a period and dimming of the display to reduce
power. This can be useful where the Graphyte has been left to
do a survey without a charging supply to maintain the battery.
This may be set to on or off. When set to off, the Graphyte will
only power off when the user turns the power off from the keypad
(or the battery runs at). When set to off, the delay setting has no
effect.
When set to on, the Graphyte will automatically turn itself off
after a period of inactivity set by the delay setting. Surveying
or pressing a button is counted as activity and resets the delay
timer. The Graphyte will never turn itself off while conducting
a survey, only after the survey completes and the subsequent
delay timer expires. Note that when conducting a long survey, it
is still recommended that the Graphyte be connected to a power
source to prevent the battery from completely discharging during
the survey.