SIRETTA SNYPER-LTE graphyte - Page 35

Registered in England No. 08405712
VAT Registration No. GB163 04 0349
Siretta Ltd
Basingstoke Road
Spencers Wood
Reading
Berkshire RG7 1PW
sales
email
web
+44(0)118 976 9000
sales@siretta.com
www.siretta.com
35
SNYPER-LTE Graphyte
User Manual
Download Latest Edition
Rev 1.7
Debug Log: This may be set to On or Off. Siretta Support may
request that this be enabled, otherwise leave the setting off. If
enabled, a debug le is created. The le is named ‘DBGLOG.
SCR’ and is found in the root of the Graphyte le system. The
le is a proprietary le format that can only be interpreted by
Siretta support. Turning debug log on will cause surveys to
take a little longer to complete.
The ‘DBGLOG.SCR’ le can grow very rapidly, so please only
enable this when requested to do so. Turning debug log off
will delete the log le, so please make sure that the log le has
been copied from the SNYPER Graphyte before doing this.
Default: Mode = On, Debug Log = Off
Set Time: Date and time can be set using the UP/DOWN
buttons.
Date: YYYY\MM\DD
Time: HH:MM:SS
Reset Menu
Factory Reset: Resets the SNYPER Graphyte to factory
settings.
NOTE: Performing factory reset will delete all saved les from the
SNYPER Graphyte’s internal memory.
Factory reset does not reset the date and time, nor does it revert
the software in the unit to the factory supplied version if it has been
updated by the user. These are the only aspects of the Graphyte
unaffected by a factory reset.
Delete Surveys: Deletes all stored surveys of all types when
selected and OK pressed.