IMPORTANT SAFETY INSTRUCTIONS
To get the most out
of
the many functions
of
this machine and operate it in safety, it is necessary
to
use this
machine
correctly.
Please
read this Instruction Manual carefully before
use
. We hope you will enjoy the use
of
your machine
for a long time.
Please remember to keep this manual in a safe place.
1.
Observe the basic safety measures, including, but not limited to the following ones, whenever you use the
machine.
2. Read
all the instructions. including, but
not
limited to this Instruction Manual before you use the
machine,
In
addition, keep this instruction Manual so that you may read
it
at anytime when necessary.
3. Use the machine after it has been ascertained that it conforms with safety rules/standards
valid in
you
r
country.
4.
All safety devices must be in position when the machine is redady for work
or
in
operation. The operation
without the specified safety devices is not
allowed.
5. This machine shall be operated by appropriately-trained operators.
6. For your personal protection. we recommend that you wear safety glasses.
7. For the
following, turn off the power switch
of
disconnect the power plug
of
the machine from the receptacie.
7.1 For threading needle (s) and replacing bobbin.
7.2 For replacing part (s)
of
needle, presser foot, throat plate,feed dog, cloth gude etc.
7.3 For repair work.
7.4 When leaving the working
place
of
when the working place is unattended.
8.
If you should allow oil, grease, etc. used with the machine and devices to come
in
contact with your eyes
or skin
or
swallow any
of
such liquid by mistake, immediately wash the contacted areas and consult a
medical doctor.
9. Tampering with the live parts and devices. regardless
of
whether the machine is powered, is prohibited.
10.
Repair, remodeling and adjustment works must only
be
done by appropriately trained technicians
or
specially skilled personnel,
11. General maintenance and inspection works have to be done by appropriately trained personel.
12. Repair and maintenance works
of
electrical components shall be conducted by qualified electric
technicians
or
under the audit and guidance
of
specially skilled personne
l.
Whenever you find a failure
of
any
of
electrical components, immediately stop the machine.
13.
Periodically clean the machine throughout the period
of
use.
14.
Grounding the machine is always necessary fot the normal operation
of
the machine. The machine has
to be operated
in
an envivronment that is free from strong noise sources such as high-frequency we
ld
er
.
15. An appropriate power plug has to be attached to the machine by electric technicians,
Power p
lu
g has to
be connected to a grounded receptacle.
16. The machine is only
allowed to
be
used for the purpese intended. Other used are not allowed.
17. Remodel or modify
th
e machine
in
accordance with the safety rules/standards while taking all the effective
safety measures. We assumes no responsibility for damage caused by remodeling
or
modification
of
the
machine.
18. Warning hints are marked with the two shown symbols.
A Danger
of
injury to operator
or
service staft
& Items requiring special attention
-ll-
To Next Page
Loading...
Need help?
General
