Sitecom WLM-3501 - Page 26

for 802.11b clients, maximum 54Mbps for 802.11g
clients, and maximum 150Mbps for 802.11n clients).
Mode
It allows you to set the router to act in “AP”, “Client”
or “WDS” mode.
SSID The SSID (up to 32 printable ASCII characters) is the
unique name identified in a WLAN. The ID prevents
the unintentional merging of two co-located WLANs.
The default SSID of the router is “default”.
Channel Width Set channel width of wireless radio. Do not modify
default value if you don’t know what it is, default
setting is ‘Auto 20/40 MHz’.
Control Sideband Select the upper band or lower band for your radio
frequency. While upper band is selected, the channel
number you can select is from channel 5 to channel
11. While lower band is selected, the channel number
you can select is from channel 1 to channel 7.
Channel Number It is the radio channel used by the wireless LAN. All
devices in the same wireless LAN should use the
same channel. Please select the country you are
located and designate a channel that the router will
use. If you want to let the router au
tomatically to find
an available channel with the highest signal strength,
please select “Auto”.
Radio Power (mW)
Set the maximum output power of the router. The
higher output power, the wider coverage range.
Associated Clients
Click “Show Active Client
s” button and you can see
the wireless clients connected to the router.
When you finish, click ‘Apply Changes’ to save the settings made and restart the
router so the settings will take effect after it reboots.