WATCH ASSEMBLY VIDEOS ON OUR YOUTUBE CHANNEL, HTTPS://SIXTHREEZERO.COM/PAGES/ASSEMBLY
03
9MM
MULTI-TOOL
04
Use a 9mm wrench/socket to loosen the nut that
clamps the shifting cable to the front derailleur. This will
disconnect the shifting cable from the front derailleur.
2 PENNIES
Lift the chain and pull the cage away from the bike
to place a penny in between the outer cage and the
largest chainwheel. If you can fit two pennies, then your
front derailleur is too high. If the penny fits snuggly in
between the outer cage and the chainwheel, you can
move to step 6.
To Next Page
Loading...
