Functional description
The camera shakes once after long-pressing the OK button. The blue light
is always on in standby mode.
The camera shakes twice after long-pressing the OK button. The blue light
flashes twice before shutting down.
The camera shakes once after pressing the OK button in the power-on
state. Then the recording starts. The blue light flashes during the recording.
Short-pressing the OK button while recording stops recording, and shakes
once. While in the recording standby state, the blue light is always on.
The WiFi is turned off by default when you turn the camera on. Press the
OK button twice to turn it on. The green light flashes quickly when WiFi is
not connected. When WiFi is connected, the green light is always on.
Press OK button twice to turn off WiFi. The green light also shuts down.
The photo mode can only be used in the App. Switch to the photo mode
from the App. The indicator light is always red. The red light flashes once
per shot.
Timelapse works inside the App. When the App switches to timelapse, the
red indicatorlight is always on. The red and blue lights keep flashing
when recording.
When the battery is too low, the camera will shake three times. Then the
red light will flash ten times quickly before shutting down the camera.
When the memory card is full, the camera will shake once. Then the blue
light will flash ten times quickly before shutting down the camera.
The charging indicator light can be found bext to the card holder. When
carging, the light is always on. After fully charged, it turns off.
The red light flashes quickly and the device will vibrate every two seconds.
10 minutes later the device will automatically shut down.
Car Mode works inside the App. The video will automatically start
loop-recording when connected to the car charger. If you unplug the
charger, the video will be automatically saved and camera turned off after
10s. Remember to switch modes from the app after using the Car Mode.
Remove the camera's memory card and plug the camera to your
computer's USB. The camera will automatically turn on, so will the blue
light. Plug & Play, no need for drivers. (Note. If you have multiple cameras
on your computer, you have to choose which one to use.)
To Next Page
Loading...
Need help?
General
