SKB Stage Five User Manual

Verify pedal power requirements and perform all cabling/setup with equipment powered off.

A common setup based on tone pedals before preamp and time pedals after preamp.

A simple setup for users new to pedals or with few pedals.

Similar to Config 2, with the addition of an amp footswitch connection.

Common pedal board setup with a time-based effect in the amp's effects loop.

True stereo setup connecting to two amps and their effects loops.

System is designed for worldwide use; select input voltage and attach appropriate power cord.

Isolated outputs prevent hum/noise; DC outputs have polarity switches for compatibility.

System supports high current AC powered effects like Digitech Whammy and Line 6 pedals.

Built-in tester verifies pedal board audio cable continuity for shorts or opens.

Provides quick testing of pedal board setups via headphone output.

Compensates for cable runs, pickup types, and provides consistent input level.

Supports connecting to front of two amps and effects loops of two amps for stereo.