Page 9
EN
The operator of the described prod-
uct must ensure that the assembly
instructions are read and understood by
all persons tasked with the assembly,
operation, maintenance, and repair of
the product. The assembly instructions
must be kept readily available.
Note that the assembly instructions
form part of the product and must
accompany the product if sold to a new
owner.
1. Safety instructions
In addition to the assembly instructions,
general statutory regulations and other
regulations for accident prevention
and environmental protection must be
observed and applied.
The described product is manufactured in ac-
cordance with the generally accepted rules and
standards of industry practice and with occu-
pational safety and accident prevention regula-
tions. Risks may, however, arise from its usage
and may result in physical harm to persons or
damage to other material assets. Therefore the
product may only be used in proper technical
condition and in observance of the assembly
instructions. In particular, any malfunctions
which may affect safety must be remedied
immediately.
1.1 Intended use
Pump units of SKF's KFG, KFGS and KFGC se-
ries are used to supply centralized lubrication
systems in vehicles, systems and machines.
They deliver oils and greases up to NLGI Grade
2.
The use of synthetic oils requires prior ap-
proval from SKF Lubrication Systems.
Any other usage is deemed non-compliant
with the intended use.
In particular, the product is neither designed
nor approved for use in conjunction with ma-
-
tion EC 1272/2008.
The product described here is neither designed
nor approved for use in conjunction with gases,
exceeds normal atmospheric pressure
(1013 mbar) by more than 0.5 bar at their
Assembly instructions
KFGS
KFG
KFGC
maximum permissible temperature.
Unless specially indicated otherwise, products
from SKF Lubrication Systems are not ap-
proved for use in potentially explosive areas as
1.2 Authorized personnel
Only qualified technical personnel may install,
operate, maintain, and repair the products de-
scribed in the assembly instructions. Qualified
technical personnel are persons who have
been trained, assigned and instructed by the
operator of the final product into which the de-
scribed product is incorporated. Such persons
are familiar with the relevant standards, rules,
accident prevention regulations, and assembly
conditions as a result of their training, experi-
ence, and instruction. They are authorized to
identify and perform necessary actions while
avoiding any risks which may arise.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in DIN VDE 0105 and
IEC 364
To Next Page
Loading...
Need help?
General
