Ski-Doo Mach Z User Manual

Section 06 ELECTRICAL
Sub-Section 04 (BATTERY)
06-04-8
Connect vent tube to vehicle fitting on front
frame.
Route RED positive cable behing retaining strip
and connect it to positive battery terminal.
Connect BLACK negative cable LAST.
CAUTION : Negative battery terminal
should always be disconnected FIRST and
reconnected LAST.
Apply silicone dielectric grease (P / N 413 7017
00) on battery posts and connectors.
Connect vent tube to vehicle fitting on front
frame.
1. Vent tube on fitting
Ensure that vent tube is not kinked or blocked.
Reinstall air silencer.
WARNING : Vent tube must be free and
open. A kinked or bent tube will restrict
ventilation and create gas accumulation that
might result in an explosion.
S Series With Electric Starting
Fasten spark plug cables to fan housing.
Reinstall throttle cable and primer hose attach-
ment to air silencer. See removal illustration.
Skandic WT
Secure battery brackets.
Connect battery cables.
CAUTION : Negative BLACK battery ter-
minal should always be disconnected
FIRST and reconnected LAST.
Apply silicone dielectric grease (P / N 413 7017
00) on battery posts and connectors.
Ensure vent tube is properly installed on battery
elbow and that is not kinked or blocked.
Reinstall air intake silencer.
Secure oil injection pump cable to air intake silenc-
er using a locking tie. Install locking tie loosely as
per following illustration.
1. Locking tie
-
A06I09A
1
;
-
A22C0BA
1

Ski-Doo Mach Z Specifications

General

Engine Displacement	899 cc
Horsepower	180 hp
Track Length	137 inches
Track Width	15 inches
Cylinders	2
Engine Stroke	2-Stroke
Cooling	Liquid
Fuel System	Electronic Fuel Injection (EFI)
Seating Capacity	1
Fuel Capacity	10.6 gallons
Brake System	Hydraulic