Section 04 ENGINE
Sub-Section 03 (599 AND 779 ENGINE TYPES)
04-03-10
ASSEMBLY
2,3, Crankshaft Bearing, Anti-seize
Lubricant and Labyrinth Sleeve
Smear anti-seize lubricant (P / N 413 7010 00) on
part of crankshaft where bearing fits.
Prior to installation, place bearings into an oil con-
tainer filled with oil previously heated to 75°C
(167°F). This will expand bearing and ease instal-
lation.
779 Engine Only
Last PTO bearing is 8 mm (5/16 in) from inner
bearing.
4, Crankcase
At crankshaft installation, position drive pins as il-
lustrated.
779 ENGINE
1. Drive pins
A. 8 mm (5/16 in)
599 ENGINE
1. Drive pins
Before joining crankcase halves, spray some acti-
vator (P / N 413 7076 00) on one of mating surfac-
es. Apply paste gasket Loctite 515 (P / N 413
7027 00) to the other mating surface.
Torque crankcase screws in the following illustrat-
ed sequence. Tightening torques are :
M6 screws : 12 N•m (106 Ibf•in)
M8 screws : 30 N•m (22 Ibf•ft)
TYPICAL
5, Water Pump Housing
Apply silicone 732 RTV on sealing surface.
Tighten water pump housing screws to 10 N•m
(90 lbf•in) following sequence as illustrated.
779 ENGINE
1. Oil level plug
A06C0HA
1
A
A06C22A
1
A06C0IA
23
6 20
17
1
15
4
13 11
8 9
7
10121416
2
1819
3
2122
5
24
A06C0SA
6 4 8
10 12
1
2
7 5
1
3 9 11
To Next Page