Skoda 2013 Rapid - Removing;Inserting; Setting in the Lower Position

Setting in the lower position
Fig. 71 Set the variable loading floor to the lower position
Fig. 72
Set variable loading floor to the lower position / variable loading
floor in the lower position
First read and observe the introductory information and safety warn-
ings
on page 70.
The variable loading floor in the upper position can be set to the lower position as
follows.
›
Grasp the variable loading floor at handle
A
» Fig. 71.
›
Lift the variable loading floor in the direction of arrow
1
and partially move in
the direction of arrow
2
until it detaches from brackets
B
.
›
Place the variable loading floor onto the floor covering of the luggage compart-
ment while tilted forward.
›
Push the variable loading floor in the direction of arrow
3
as far as it will go,
and until its front part
C
» Fig. 72 is raised.

›
Place the variable loading floor in direction of arrow
4
.
CAUTION
When setting the variable loading floor to the lower position, the luggage com-
partment cover must not be in the “parking position” » page 68.

Removing/inserting
Fig. 73
Remove variable loading floor
First read and observe the introductory information and safety warn-
ings on page 70.
Removing
›
Grasp the variable loading floor at handle
A
» Fig. 73.
›
Lift the variable loading floor in the direction of arrow
1
until its rear area is
about 15 cm
B
below the luggage compartment cover » .
›
Remove the variable loading floor from the vehicle by moving it in the direction
of arrow
2
.
Inserting
›
Grasp the variable loading floor at handle
A
» Fig. 73.
›
Insert variable loading floor into the vehicle with the front portion tilted about
15 cm
B
beneath the luggage compartment cover» .
›
Then follow the same steps as when setting the upper position » page 71, Set-
ting in the upper position or the lower position » page 72, Setting in the lower
position .


72
Using the system