■
Delete lists - Delete device lists
■
Known devices - Delete the list of known devices
■
Device blocked - Delete the list of blocked devices
■
Both lists - Delete both device lists
■
Password - Use of password to log on to the WLAN network
■
Show - Display a password to log on to the WLAN network
■
Generate - Generate a new password to log on to the WLAN network
■
Wi-Fi Name - Use of WLAN network name
■
Show - Display the WLAN network name
■
Rename - Rename the WLAN network
■
WPS config. - Wi-Fi network connection using WPS
■
Pushbutton - Automatic connection
■
WPS PIN - PIN entry for the connection
■
Data counter - Display information about the volume of data transferred
■
Current conn. - display of the volume of data transferred for the current
connection
■
Total - Display of the total volume of data transferred
■
Reset - Resetting of the information about the volume of data transferred
■
Settings - WLAN network settings
■
Access point - Access point settings
■
Settings - Access point management
■
APN - Change the access point name
■
User name - User Name
■
Password - Password
■
Reset - Reset access point factory settings
■
Prioritisation - Set the connection priority
■
Calls - Set the connection priority for calls
■
Data - Set the connection priority for data transfer
■
Encryption- Set the encryption
■
WPA2 - Enable WPA 2 encryption
■
Open - No encryption
■
Visibility - Set the WLAN network visibility
■
Visible - WLAN network is visible to other devices
■
Invisible - WLAN network is not visible to other devices
■
Data roaming - Set the data roaming
■
No roaming - Data roaming is not allowed
■
Allow - Data roaming is allowed
■
Always ask - Question setting for data roaming
■
Wi-Fi Channel - Select WLAN network channels (preferably set to channel
11)
■
Channel 1 ... Channel 11 - Display the WLAN network channels
■
Reset - Reset Wi-Fi network factory settings
Voice control
Introduction
This chapter contains information on the following subjects:
Dialogue
121
Voice commands - GSM II 122
Voice commands - GSM III 123
Dialogue
Fig. 115
Multifunction steering wheel
The voice control system (hereinafter referred to as the system) makes it pos-
sible to use voice commands for some functions of the hands-free system.
The period of time during which the system is ready to receive voice com-
mands and to carry them out is called a dialogue. The system gives audible
feedback and guides you if necessary through the relevant functions.
Optimum understanding of the voice commands depends on several factors.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
Close the doors, windows and sliding roof, to reduce or stop disturbing exte-
rior noise.
›
You are recommended to speak louder at higher speeds, so that the sound of
your voice is not drowned out by the increased ambient noise.
121
Communication and multimedia
To Next Page
Loading...
