EasyManua.ls Logo

Skoda 2014 Yeti - Automatic Driving Lamp Control; Turn Signal and Main Beam

Skoda 2014 Yeti
238 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Turn signal and main beam
Fig. 44
Operating lever: Turn signal and
main beam operation
Read and observe on page 62 first.
Lever positions
A
Switch on right turn signal
B
Switch on left turn signal
C
Switch on high beam (spring-loaded position)
D
Switching off main beam / switching on headlamp flasher (spring-
loaded position)
Main beam
The main beam can only be switched on when the low beam lights are on.
When the high beam or headlight flasher is on, the warning light
illuminates
in the instrument cluster.
Flashing
When the left flashing light is switched on, the warning light
flashes in the
instrument cluster.
When the right flashing light is switched on, the warning light
flashes in the
instrument cluster.
The flashing light is turned on even before the upper and lower pressure point.
This is advantageous with some manoeuvres. For example, when changing
lanes hold the control lever of each pressure point.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
The indicator light flashes at twice its normal rate if a bulb for the turn signal
light fails.
“Convenience turn signal”
If you only wish to flash three times, briefly push the lever to the upper or low-
er pressure point and release again.
The “Lane ch. flash” can be activated or deactivated via the Maxi DOT display in
the Lane ch. flash» page 45, Settings menu item.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.
Note
The headlight flasher system can also be operated if the ignition is switched
off.
Automatic driving lamp control
Fig. 45
Light switch: AUTO position
Read and observe on page 62 first.
If the light switch is in position

» Fig. 45, the parking lights, low beam and
number plate lights are switched on or off automatically.
Switching on/off of the light is regulated on the basis of data gathered by the
sensor fitted in the holder of the rear-view mirror below the windscreen.
If the light switch is in position

, the lettering

illuminates next to the
light switch. If the light is switched on automatically, the symbol
next to the
light switch also lights up.
64
Using the system

Table of Contents

Related product manuals