›
Fold up the variable loading floor by moving it in the direction of the arrow
2
.
Dividing the luggage compartment
Fig. 148
Dividing the boot with variable
loading floor
The luggage compartment can be divided with the variable loading floor in the
lower and upper position.
›
Raise the rear of the variable loading floor by the handle
A
» Fig. 148.
›
Push the rear edge of the variable loading floor into the grooves
B
in the
direction of the arrow.
The variable loading floor is secured against movements in the grooves
B
.
Net partition
Introduction
This chapter contains information on the following subjects:
Using the net partition
116
Removing and refitting the net partition housing
117
The net partition can either be extracted from behind the rear seats or behind
the front seats.
This chapter describes the procedure for extracting and rolling up the net par-
tition behind the rear seats.
Installing and removing the net partition from behind the front seats is carried
out in a similar way as behind the rear seats. Before removing the net parti-
tion, the rear seat backrests should be folded forwards. After rolling up the net
partition in the housing, the rear seat backrests should then be folded back
» page 85.
Using the net partition
Fig. 149 Open part of the roll-up luggage compartment cover / release
lever
Fig. 150 Correctly secure net partition behind the front seats in the
pulled-out state
Removing the net partition behind the rear seats
›
Fold out part of the roll-up luggage compartment cover
A
in the direction of
the arrow » Fig. 149.
›
Pull out the net partition at the upper crossbar
C
from the housing
D
» Fig. 150.
›
Insert the transverse rod into one of the mounts
E
and push forwards.
›
Insert the transverse rod into the mount
E
on the other side of the vehicle
in the same way.
›
Make sure that the crossbar is firmly seated in the fittings
E
.
116
Using the system
To Next Page
Loading...
