WARNING
■
For your own safety and that of other road users, ensure that all the win-
dows are free of ice, snow and misting. The blower should always be on to
prevent the windows from misting up.
■
Under certain circumstances, air at a temperature of about 5 °C can flow
out of the vents when the cooling system is switched on.
CAUTION
■
The air inlet in front of the windscreen must be free of e.g. ice, snow or
leaves to ensure that the heating and cooling system operates properly.
■
After switching on the cooling Condensation from the evaporator of the air
conditioning may drip down and form a puddle below the vehicle. This is not a
leak!
■
If the coolant temperature is too high, the cooling system is switched off to
ensure that the engine cools down.
Heating and manual air conditioning
Fig. 153 Heating Controls
Fig. 154 Controls of the manual air conditioning
Read and observe and on page 119 first.
Individual functions can be set and switched on by turning the rotary switch or
by pressing the button in question. When the function is switched on, the indi-
cator lamp below the button lights up.
Functions of the individual controls » Fig. 153 and » Fig. 154
Setting temperature
▶
Lower the temperature
▶
Increase the temperature
Set the blower speed (Level 0: fan off, Level 6: high speed)
Set the direction of the air flow » page 122
▶
Air flow to the windows
▶
Air flow to the upper body
▶
Air flow into the footwell and to the body (warmer air directed to the
footwell than to the body)
▶
Air flow to the footwell
▶
Air flow to the windows and the footwell
Depending on equipment fitted:
▶
Auxiliary heating and ventilation on / switch off » page 124
▶
Switching the windscreen heater on/off » page 75
Operate seat heating for the front left seat » page 88
Switching the cooling system on/off
Switch the heated rear window function on/off » page 75
Switch recirculation on/off » page 122
Operate seat heating for the front right seat » page 88
A
B
C
D
119
Heating and ventilation
To Next Page
Loading...
