Opening from the boot
›
Push the unlock button
B
in the direction of the arrow » Fig. 81 and fold the
cover including the armrest forwards.
Closing
›
Fold the cover and rear armrest upwards to the stop - the cover must click
into place.
Ensure that the armrest is always locked into place after closing the cover.
This is apparent as the red field above the unlocking button
B
» Fig. 81 is not
visible from the boot.
WARNING
The through-loading channel is only intended for transporting skis that are
placed in a properly secured, through-loading bag.
Head restraints
Introduction
This chapter contains information on the following subjects:
Height adjustment
87
removing and installing 87
WARNING
Please note the following points about the head restraint settings
» page 8, Correct and safe seated position.
Height adjustment
Fig. 82
Front head restraint: moving it
up and down
Fig. 83 Rear head restraint: moving it up / down
Read and observe on page 87 first.
Adjust front support
›
Press and hold the safety button
A
» Fig. 82.
›
Move the supports into the required position.
Adjust rear support
›
Grasp the restraint and move upwards in the direction of
1
» Fig. 83.
›
In order to push the supports downward, press the safety button
B
in the
direction of arrow
2
and hold down.
›
Press in the support in the direction of arrow
3
.
removing and installing
Fig. 84 Rear head restraint: removing / fitting
Read and observe on page 87 first.
Only the real head restraints may be removed or installed.
87
Seats and head restraints
To Next Page
Loading...
