Skoda OCTAVIA MK1 - Removing and Installing Engine Covers; Testing Lines and Components with the Test Box -V.A.G 1598;22

G :%$>&%%&
7 )
+7 = ::%
7 /!
7 =<  :%
57 &M$ 
, %&!%$ !
Removing
–
Lever out the plugs -1- at the points marked
with arrows and slacken the securing nuts -2-
for both engine covers.
–
Slacken the securing nut -3- and remove the
engine covers.
Install
Installation is carried out in the reverse order. Pay
attention to the following:
–
Tighten securing nuts to 8 Nm and press in the
plug.
!!%&$ : !@99!< E7-+45""7
) 
 !9%&;7-+"79 %!7-+"7> 9!

!%&%:$%<!> %&%:$%<!> $ $9!A;: 9!
< E7-+47

9$ %$;<! >9$ $  >9$  ;%&9! $;<! >9
!< E%&$%
G  $$ $ %$  ;@99 !!@$9& K




4