Skoda OCTAVIA MK1 - Adapt the Engine Control Unit to the Electronic Immobiliser

D 9%:

&%:9$  ; 9
9 %$  ;780057
D 9%:

&%:9$  ; 9
$ $ <!D 9%:
&%:9$  ; 9$ $ <!
Special tools and workshop equipment required
t Vehicle system tester -V.A.G 1552 - with cable -V.A.G 1551/3-
Test condition
l Authorised car key available
– Connect vehicle system tester -V.A.G 1552- with cable -V.A.G 1551/3 -.
– Switch on ignition.
– Enter 17 for the address word “dash panel insert” and confirm the entry with Q.
At the display is shown e.g°:
– Press → key.
1U1919034J A+-COMBIINSTR.VDO X27 ->
Coding 02142 WSC xxxxx
At the display is shown e.g°:
– Press → key.
IMMO-IDENT NO: SK27Z0W0095705 ->
The following appears in the display:
–
Enter 10 for the function “Adaptation” and confirm with
Q.
Vehicle system test
HELP
Select function XX
The following appears in the display:
– Enter 00 and confirm with the Q key.
Adjustment
Enter channel number XX
The following appears in the display:
– Confirm the entry with the key Q.
Adaptation Q
Erase initialisation values?
The following appears in the display:
– End adaptation by pressing the → key.
Note
When the ignition is switched on again the engine control unit
identification is read by the immobilizer control unit.
Adaptation
->
Initialisation values erased
4