Skoda OCTAVIA MK1 - Inspecting the Cylinder Head for Distortion; Reworking a Cylinder Head

9%&
G
!$@>$ %M%%$'&
9%&
G 1; ;$ %:: @%&!9>
G , $'&9%&$ D 9%:
G
,%!9$'&9%&< !9
& 2
G
, $'&9%&@9$'&9%&
%!


!:$9$'&9%&> &!  
Special tools and workshop equipment required
t Feeler gauge
t Knife-edge straightedge
Test sequence
–
Inspect cylinder head at several points for
distortion using a knife-edge straightedge and
feeler gauge.
t max. permissible distortion: 0.1 mm
,@ %$'&9%&
1 $&;
 
+