Skoda OCTAVIA - Page 105

Attaching the rear headrests
Fig. 121 Inserting: adapter/holder
Fig. 122
Removing: holder/adapter
Read and observe
on page 102 first.
›
Toinsert, attach the opened adapter to the guide rods of the front headrest
and clip in the direction of arrow
1
» Fig. 121 » .
›
Clip in the holder in the direction of arrow
2
into the adapter.
›
To remove, pull on the securing tab
A
in direction of arrow
3
and take the
holder out of the adapter in the direction of arrow
4
» Fig. 122.
›
Press the adapter and remove in the direction of the arrow
5
from the
guide rods of the headrest.
WARNING
Be careful with the adapter- otherwise there is a risk of finger injury.

Handling the holder
Fig. 123 Tilting and rotating the holder
Fig. 124
Adjusting the holder size
Read and observe on page 102 first.
The holder may be by 30° in the direction of the arrow
1
tipped and by 360°
in the direction of arrow
2
turned » Fig. 123.
›
To
adjust the holder size, pull out the securing tab
A
in the direction of ar-
row
3
and push the part
B
in the direction of arrow
4
to the desired posi-
tion » Fig. 124.
Note
If there is no external device in the holder, then we recommend that the part
B
is moved down fully. Otherwise, irritating noise may occur at certain
speeds.

103
Practical features