Fold forward from the luggage compartment
On vehicles with a net partition, the left and then the right and middle rear seat
backrest must first be unlocked. The net partition must be rolled up in the
housing.
›
Pull the corresponding lever in the direction of the arrow » Fig. 89. The re-
spective seat backrest is unlocked or folded forward.
Folding backwards
›
Pull the seat belt
C
for the side panel in the direction of arrow
3
» Fig. 88.
›
Raise the seat backrest against the direction of arrow
2
until the release
handle
A
audibly locks. Check this by pulling on the seat backrest.
›
Make sure that the red pin
B
is hidden.
In the undivided seat back, pull the two outer belts to the side panel. After
folding back the backrest, the release handles
A
should audibly click into
place on both sides of the backrest and the red mark
B
should not be visible
on either side of the backrest.
WARNING
■
The seat backrests in the occupied rear seats must be properly engaged.
■
When transporting objects in the luggage compartment that has been en-
larged by folding the backrest forward, ensure the safety of the passengers
transported on the other rear seats.
■
The seat backrests must be securely latched in position so that no objects
from the luggage compartment can slip into the passenger compartment
under sudden braking – risk of injury.
CAUTION
When operating the seat backrests, the seat belts must not be pinched - there
is a risk of damage to the seat belts.
Fold down armrest
Fig. 90
Fold down armrest
The armrest can be folded down by pulling on the loop
A
in the direction of
arrow » Fig. 90.
The folded-down armrest can be used as a side table.
Headrests
Introduction
Note
In sports seats, the headrests are integrated into the seat backrests and can-
not be adjusted in height.
Adjust height of front head restraint
Fig. 91
Setting the height of the front
headrest
›
To adjust the height, hold the locking button
A
and move the rest in the de-
sired direction » Fig. 91.
89
Seats and head restraints
To Next Page
Loading...
