Seats and Stowage 93
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
Partially pulling out the variable loading floor*
Fig. 87 Luggage compartment: partially pulling out the variable loading floor
The variable loading floor can be partially pulled out over the rear bumper. The vari-
able loading floor which is pulled out in such a way is solely used as a seat, for example
for changing shoes. When pulling out the variable loading floor, the front edge (close
to the rear seats) is lifted at the same time. Thus, small objects can no longer fall into
the space between the luggage compartment floor and the variable loading floor.
– Grasp the rear part of the variable floor at the handle, raise it slightly in direction of
arrow fig. 87 and pull it over the bumper in direction of arrow until it
engages in the opening fig. 87.
– Grasp the part of the floor at the handle, raise it slightly in direction of arrow and
push it forwards up to the stop in order to push in the variable loading floor.
Ensure that the raised front edge of the variable loading floor is not damaged.
Dividing the luggage compartment with variable loading floor*
The luggage compartment can be divided with the variable loading floor.
– Grasp the rear part of the floor at the handle, raise it in direction of arrow
page 93, fig. 87 and insert the rear edge in one of the openings fig. 88.
The variable loading floor is secured in the openings against movement.
The variable loading floor can be pulled out some more before dividing the luggage
compartment with the variable loading floor page 93. This enlarges the space
between the rear seats and the separation.
To Next Page
Loading...
