Seats and Stowage96
If you wish to use the entire luggage compartment, you can remove the foldable
luggage compartment cover page 91, fig. 84.
First check for yourself that the cross road is inserted into the mounts in the
front position!
Using the net partition behind the front seats
Pulling out
– Fold the rear seats forwards (see Owner's Manual).
– Pull the net partiton at the bracket fig. 94 out of the housing .
– Insert the cross rod into the mount first on the one side and push the cross rod
forwards.
– In the same way, fix the cross rod to the other side of the vehicle, mount .
Folding
– Pull the cross rod back slightly, first on the one side then on the other side and take
the cross rod out of the mounts fig. 94.
– Hold the cross rod in such a way that the net partition can roll up into the housing
slowly and without damage.
– Fold the rear seats back into their original position.
The belt locks and the belts must be in their original position after folding
back the seat cushions and the seat backrests - they must be ready to use.
The seat backrests must be securely interlocked in position so that no
objects in the luggage compartment can slide forwards if there is sudden
braking - risk of injury!
First check for yourself that the cross road is inserted into the mounts in
the front position!
Pay attention that the rear seat backrest is correctly interlocked. It is only
then that the three-point seat belt for the middle seat can reliably fulfil its
function.
Removing and installing net partition housing
Removing
– Fold the rear seats forwards (see Owner's Manual).
– Open the right rear door.
– Push the net partition housing fig. 95 in the direction of arrow and take it
out of the mount of the rear seats in the direction of arrow .
Installing
– Position the net partition housing into the mounts of the rear seat backrests.
Fig. 94 Pull out the net partition
Fig. 95 Rear seats: Net partition housing
s3fg.2.book Page 96 Friday, April 30, 2010 12:17 PM
To Next Page
Loading...
