Breakdown assistance 253
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
• It is important to support the vehicle with suitable supporting
blocks if you wish to work under the lifted vehicle - risk of injury!
Taking off and fitting on wheel
After you have slackened the wheel bolts and have raised the car
with the car jack, replace the wheel as follows:
Changing a wheel
– Turn the wheel bolt which is farthest to the top fully out with
the hexagon socket in the screwdriver handle (car tool kit)
and place the bolt down on a clean surface ⇒ fig. 192.
– Screw the assembly pin (car tool kit) into the vacant hole
⇒ fig. 193.
– Unscrew the remaining wheel bolts as described above.
– Take off the wheel.
Fitting on wheel
– Push the spare wheel over the assembly pin.
WARNING (continued)
Fig. 192 Changing a
wheel: Remove bolts
with hexagon in screw-
driver
Fig. 193 Changing a
wheel: assembly pin
.
,
.
To Next Page
Loading...
