Fuses and light bulbs266
Changing the bulb for interior light of vehicles without an
electric sliding/tilting roof
– Insert a small screwdriver into the slot next to the light
⇒ page 265, fig. 202.
– Carefully press out the light and remove it from the headliner.
– Take the faulty bulb out of and insert a new one.
– First of all place the lights in the mounts at the rear and press
them into the headliner, until they lock into place.
Changing the bulb for interior light of vehicles with an
electric sliding/tilting roof
– Position a small screwdriver carefully against the rear edge of
the cover of the power roof drive - arrows 1- ⇒ page 265,
fig. 203.
– Lever off the cover down carefully.
– Insert a small screwdriver into the slot next to the light - arrow
2-.
– Carefully press out the light and remove it from the headliner.
– Take the faulty bulb out of and insert a new one.
– First of all place the lights in the side plastic mounts and press
them upwards, until they lock into place.
– Press on the cover again by first of all inserting the plastic lugs
and then pushing the cover up.
Interior lights at the rear
Changing the bulb for lights without interior monitoring
sensors
– Insert a small screwdriver into the slot next to the light cover
⇒ fig. 204 and carefully lever the cover off.
– Take the faulty bulb out of and insert a new one.
– Insert the cover and press it in fully until it locks in place.
Changing the bulb for lights with interior monitoring
sensors
– We recommend having these bulbs replaced by a Škoda
dealer.
Fig. 204 The interior
light at the rear without
interior monitoring
sensors
.
,
.
To Next Page
Loading...
