Seats and Stowage72
Adjusting front seats manually
Adjusting a seat in a forward/back direction
– Pull the lever ⇒ fig. 54 up and push the seat into the
desired position.
– Release the lever and push the seat further until the lock
is heard to engage.
Adjusting height of seat
– Lift the seat if required by pulling or pumping lever
⇒ fig. 54 upwards.
– Lower the seat if required by pushing or pumping lever
downwards.
Adjust the angle of the seat backrest
– Relieve any pressure on the backrest (do not lean on it) and
turn the handwheel to adjust the angle of the backrest.
Adjusting Lumbar support
– Turn the handwheel until you have set the most comfort-
able curvature of the seat upholstery in the area of your spine.
The driver's seat should be adjusted in such a way that the pedals can be
pressed to the floor with slightly bent legs.
The backrest on the driver's seat should be adjusted in such a way that
the upper point of the steering wheel can be easily reached with slightly
bent arms.
WARNING
• Only adjust the driver seat when the vehicle is stationary - risk
of injury!
• Take care when adjusting the seat! Adjusting the seat without
care can lead to bruises or injuries.
• The backrests must not be angled too far back when driving
otherwise this will affect proper operation of the seat belts and of
the airbag system - risk of injury!
Fig. 54 Controls at
driver seat
1
1
2
2
3
4
.
,
,