Fuses and light bulbs 225
Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data
Interior lights at the front
Changing the bulb for interior light of vehicles without an electric
sliding/tilting roof
– Insert a small screwdriver into the slot next to the light ⇒ fig. 206.
– Carefully press out the light and remove it from the headliner.
– Take the faulty bulb out of and insert a new one.
– First of all place the lights in the mounts at the rear and press them into
the headliner, until they lock into place.
Changing the bulb for interior light of vehicles with an electric
sliding/tilting roof
– Position a small screwdriver carefully against the rear edge of the
cover of the power roof drive - arrows 1- ⇒ fig. 207.
– Lever off the cover down carefully.
– Insert a small screwdriver into the slot next to the light - arrow 2-.
– Carefully press out the light and remove it from the headliner.
– Take the faulty bulb out of and insert a new one.
– First of all place the lights in the side plastic mounts and press them
upwards, until they lock into place.
– Press on the cover again by first of all inserting the plastic lugs and
then pushing the cover up.
Interior lights at the rear
Changing the bulb for lights without interior monitoring sensors
– Insert a small screwdriver into the slot next to the light cover
⇒ fig. 208 and carefully lever the cover off.
B1Z-0042HB1Z-0042H
Fig. 206 Interior lights at
the front for vehicles
without an electric
sliding/tilting roof
B1Z-0042HB1Z-0042H
Fig. 207 Interior lights at
the front for vehicles with
an electric sliding/tilting
roof
B1Z-0042HB1Z-0042H
Fig. 208 The interior
light at the rear without
interior monitoring
sensors
To Next Page
Loading...
