The following message is shown in the MAXI DOT display.
Gearbox overheated. Stop! Log book!
do not continue to drive! Stop the vehicle, switch off the engine, and wait
until the
icon goes out – risk of gearbox damage! You can continue your
journey as soon as the symbol disappears.
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe
distance from the traffic, switch off the engine and activate the hazard
warning lights system » page 70. The warning triangle must be set up at
the prescribed distance - observe the national legal provisions when doing
so.
Note
■
If the MAXI DOT display shows warning messages, these messages must be
confirmed in order to access the main menu » page 40 .
■
As long as the operational faults are not rectified, the symbols are always in-
dicated again. After they are displayed for the first time, the symbols continue
to be indicated without any extra messages for the driver.
Warning lights
Introduction
This chapter contains information on the following subjects:
Handbrake 33
Brake system 33
Seat belt warning light 33
Generator 33
Door open 34
Engine oil pressure 34
Coolant 34
Bonnet 34
Boot lid 34
Power steering / steering lock (system KESSY) 34
Engine oil level 35
Traction Control System (ASR) 35
Electronic Stability Control (ESC) 35
Antilock brake system (ABS) 36
Rear fog light 36
Lamp failure 36
Adaptive headlights (AFS) 36
Exhaust inspection system 36
Glow plug system (diesel engine) 36
Engine performance check (petrol engine)
37
Diesel particulate filter (diesel engine) 37
Fuel reserve 37
Airbag system 38
Tyre inflation pressure 38
Windscreen washer fluid level 38
Pads 38
Turn signal system 38
Low beam 39
Fog lights 39
Cruise control system 39
Selector lever lock / starter (system KESSY) 39
Main beam 39
The warning lights indicate certain functions or faults.
Some warning lights can be accompanied by acoustic signals and messages in
the display of the instrument cluster.
After switching on the ignition, some warning lights illuminate briefly as a
function test.
If the tested systems are OK, the corresponding warning lights go out a few
seconds after switching on the ignition or after starting the engine.
32
Operation
To Next Page
Loading...
