Tyre pressure monitoring system
Functionality
The system measures tyre pressure while driving us-
ing sensors on the wheels.
For correct system function, you must select the
tyre type as well as the load condition of the vehicle
in the Infotainment.
After switching on the ignition, the last measured
tyre pressure values are displayed. This display will
be updated at the start of the journey.
Warning when changing the tyre pressure
illuminates
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Overview
Display in the instrument cluster
›
Select
Vehicle
Display in Infotainment
›
In the following menu, select the menu item for
displaying the vehicle condition.
Or:
›
Using the functional surfaces choose the Tyre
Pressure Monitoring menu item.
Instrument cluster / Infotainment
Tyre pressure
B
Recommended tyre pressure
C
Tyre pressure not available
D
Tyre pressure too low
E
Setting the vehicle's load condition
The tyres warm up while driving and there is an
increase in pressure. This is completely normal, it is
not a defect. If the system shows an increase in
pressure while driving, do not reduce the pressure.
Settings
Tyre type
Select the tyre type in the following menu.
Or:
Vehicle loading condition
›
In the following menu, select the menu item for
displaying the vehicle condition.
Or:
›
Using the functional surfaces choose the
Tyre
Pressure Monitoring
menu item.
›
Tap the functional area and select the vehicle
load condition.
Troubleshooting
Functional restriction / system fault
flashing
›
Stop the engine and start again.
›
If the indicator light flashes again after the engine
starts, there is a problem with the system.
›
Continue driving, exercising appropriate caution,
and seek the help of a specialist garage.
Wheel bolt cover caps
Pull o and install cover caps
Pull o
›
Push the pull-o clamp onto the cover cap up to
the stop.
›
Pull o the cover cap.
Install
›
Push the cover cap onto the wheel bolt to the stop.
196
Wheels › Tyre pressure monitoring system
To Next Page
Loading...
