Full wheel frame
Pull o panel and install
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
›
Hang the bracket for pulling o the wheel covers
at the edge of one of the openings in the cover.
›
Push the wheel wrench through the bracket, sup-
port it on the tire and pull o the cover.
Install
›
Place the cover on the intended valve section on
the rim.
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
›
Press the trim, starting at the valve, into the rim on
both sides until it engages around the entire cir-
cumference.
NOTICE
▶
Use hand pressure, do not hit the wheel cover.
Pull o and install the aero cover
Applies to factory installed covers or covers deliv-
ered with ŠKODA original accessories.
Remove
›
Hook the bracket to remove the wheel covers at
the edge of the panel as close to the centre as pos-
sible.
›
Loosen the centre of the wheel cover by pulling
and pull o the cover.
To make removal easier, it is possible to insert the
wheel wrench through the bracket loop and pull on
the two key ends.
Install
›
If an anti-theft wheel bolt is used, it must be in the
position marked on the cover.
›
Place the cover on the wheel rim and press in the
individual spokes of the cover one after the other
until they engage completely.
›
Press in the centre of the wheel cover until it clicks
into place.
NOTICE
▶
Use hand pressure, do not hit the wheel cover.
197
Wheels › Full wheel frame
To Next Page
Loading...
