Remove and insert
Remove
›
Remove the roll-up cover.
›
Take out the folded pocket in an upwards direc-
tion.
Insert
›
Insert with marked
end of the bar in the
right holder and in
the left holder.
Net partition
Attach the net partition
Attach at the back
›
Open the lid of the roll-
up cover.
›
Pull out the net parti-
tion.
›
Insert the crossbar into
the mount on one side
and push it forwards.
›
Fix the bar in the same
way on the other side.
›
Open the lid of the
roll-up cover.
Fasten in the front
The procedure is analogous to the process behind.
Before installing, fold back the rear seat backrests.
Releasing
›
Open the lid of the roll-up cover.
›
Move the rod first to one side and then to the oth-
er side, and take it out of the supports.
›
Hold the pole and allow the net partition to slowly
roll in.
›
Open the lid of the roll-up cover.
Remove housing and insert
Removal
›
Fold the rear seat backrests forwards.
›
Open the door at the right rear.
›
Move and swing out
the housing.
Inserting
›
Insert the housing into
the supports and move
it.
Troubleshooting
Blocked net partition
›
To unlock, press the
lock button.
Rigid boot cover
Removing and inserting
The maximum load of the other fastening nets is
1 kg.
200
Storage space and interior equipment › Net partition
To Next Page
Loading...
