After moving the switch to position B , the slid-
ing / tilting roof opens into the low-noise position (at
a speed of approximately 80 km / h).
After another shift to position B , the sliding / tilting
roof opens completely.
After switching o the ignition, the sliding / tilt-
ing roof can be operated for about 10 minutes as
long as none of the doors are opened.
Easy operation of the sliding / tilting roof
The comfort operation makes it possible to lock the
sliding/tilting roof with the key if necessary.
›
To tilt, hold the button
down.
›
To close, hold the button down.
On vehicles with a keyless locking system, it is possi-
ble to close the sliding / tilting roof using the sensor
in the door handle of the front door .
›
Hold one finger on the sensor on the outside of the
handle on the front door.
Troubleshooting
Operation of the sliding/tilting sunroof does not
work after disconnecting the vehicle battery
›
Activate the operation of the sliding/tilting
roof » page 32.
Activation after disconnecting the vehicle
battery
Activation of the operation of the sliding/tilting
roof
›
Turn on the ignition.
›
Pull the switch all the way down and hold it down.
After about 10 secs, the sliding/tilting roof opens
and closes again.
›
Release the switch.
Sunblind - with manual operation
service
›
Pull the handle in the
appropriate direction.
Sunblind - with electrical operation
Operation
Open
Close
›
Press or hold the but-
ton to move the blind .
›
Press or release the
button to stop the
blind from moving .
Activation after disconnecting the vehicle
battery
›
Turn on the ignition.
›
Keep the
button pressed down. The sunblind
opens and closes again.
›
Release the button.
Sunblind for the rear window
service
Stopping down
›
Pull out the sun blind from the handle and hang it
in
brackets A.
32
Doors, windows and boot lid › Sunblind - with manual operation