Why is my Skov DA 175 Controller motor not running smoothly?
The motor may not be running smoothly because it is running in limited mode. To resolve this, remove any overload, such as potentially excessive air inlets.
What to do if the Skov DA 175 Controller motor runs a little back-and-forths?
If the motor runs a little back-and-forths, it may be due to a missing ground wire/GND wire. Connect 2 ground wires/GND wires to the motor to resolve this issue.
Why does my Skov DA 175 Controller display 'MAN'?
The 'MAN' display indicates a temporary service mode. To return to normal operation, press the AUTO button.
What to do if my Skov DA 175 motor runs on its own when 'MAN' is displayed?
The motor running on its own while 'MAN' is displayed indicates a temporary service mode, which is activated when IN or OUT are pressed for 3 seconds. To return to normal operation, press the AUTO button.
General| Brand | Skov |
|---|---|
| Model | DA 175 |
| Category | Controller |
| Language | English |
Lists various accessories for the DA 175 actuator, including mounting plates and protection kits.
Lists essential tools required for the assembly of the DA 175 actuator.
Illustrates various installation scenarios for the DA 175 actuator in different inlet configurations.
Provides instructions on the proper placement and mounting height of the DA 175 actuator.
Details procedures for mounting the actuator on different wall materials like brick and concrete.
Instructions for mounting the DA 175 on a solid brick wall, specifying dowels and screws.
Steps for mounting the DA 175 on a cellular brick wall using mounting plates and bolts.
Guidance on installing the DA 175 on a solid concrete wall using dowels and screws.
Instructions for mounting the DA 175 on porous concrete walls using mounting plates and bolts.
Details mounting the DA 175 on sandwich walls, recommending proximity to a steel truss.
Explains how to mount cable glands on the DA 175 actuator and secure the cover.
Instructions for mounting cables in M20 cable glands, ensuring correct orientation and securing.
Guide on setting the correct supply voltage for the DA 175 actuator before connecting power.
Explains how to configure the DA 175 actuator's function using jumpers on the circuit board.
Provides general information on circuit diagrams, including color and letter codes.
Details cable plans and circuit diagrams for the DA 175 24 V DC models.
Provides the specific circuit diagram for the DA 175 24 V model in ON/OFF control mode.
Shows the circuit diagram for the DA 175 24 V model configured for stepless control.
Presents the circuit diagram for the DA 175 24 V model operating in analog control mode.
Details cable plans and circuit diagrams for the DA 175 230 V models.
Provides the specific circuit diagram for the DA 175 230 V model in ON/OFF control mode.
Shows the circuit diagram for the DA 175 230 V model configured for stepless control.
Presents the circuit diagram for the DA 175 230 V model operating in analog control mode.
Explains the different operating modes (AUTO, MAN) and control inputs (IN, OUT, SET).
Step-by-step guide for calibrating the DA 175 actuator to set its end positions.
Provides instructions on how to clean the DA 175 actuator, advising against certain agents.
Offers guidance on recycling and proper disposal of the DA 175 product.
Lists common symptoms, causes, and solutions for issues encountered with the DA 175 actuator.
Details control signals, cable leads, and expected results for different jumper settings.
Lists electrical, mechanical, environmental, and shipment specifications for the DA 175 24 V DC.
Provides electrical, mechanical, environmental, and shipment specifications for the DA 175 230 V.
Presents detailed dimensional drawings and measurements for the DA 175 actuator.
To Next Page
