·Low level equipment should be mounted away from power amplifiers to avoid induction of this type of hum.
·Be certain that all audio wiring except for loudspeaker lines is well shielded, and that low level wiring is not run
parallel to and /or in close proximity to AC power wiring.
INTERMITTENT AUDIO
·Check the other equipment and the wiring to make certain that the signal is not intermittent earlier in the chain.
·Check the integrity of all cables using a cable tester.
STEREO 2-WAY-MODE
In 2-way stereo mode the controls are marked BELOW the horizontal blue line.
Channel one and Channel Two functions are identical in the stereo mode. LEDs are disabled for controls which
are non-functional in this mode.
[1]&[5] INPUT GAIN Controls the INPUT level with +/- 12dB of gain.
[9]&[15] LOW CUT Switch for selecting the 40 Hz high pass filter. An LED indicates the selection.
[2]&[6] LOW/HIGH Selects crossover point between the LOW and HIGH output
[10]&[16] x10 LED Indicates that the LOW/HIGH crossover frequency range is 450 Hz to 9.6 kHz.
[3]&[7] LOW OUTPUT Controls the low Frequency output level with a range of -∞to +6dB.
[11]&[17] PHASE INVERT Switch for reversing the polarity on the low output. An led indicate the
selection.
[4]&[8] HIGH OUTPUT Controls the high frequency output with a range of -∞ to +6-dB.
[12]&[18] PHASE INVERT Switch for reversing the polarity on the high output. An led indicates the
selection.
[14] STEREO Led indicating stereo mode operation.
MONO 3-WAY MODE
In 3 -way mono operation the controls are marked ABOVE the horizontal blue line. Front panel controls not
described in this section are not active in mono 3-way mode. LEDs are disabled for controls which are
nonfunctional in this mode.
[1] INPUT GAIN Controls the input level with +/- 12dB of gain.
[9] Low CUT Switch for selecting the 40 Hz high pass filter. An led indicates the selection.
[2] LOW/MID Selects crossover point between low and mid frequencies.
[10] x10 LED Indicates that the Low/MID crossover range is 450 Hz to 9.6 kHz.
[6] Mid/High Selects the crossover point between MID and HIGH frequencies.
[16] x10 LED Indicates that the MID/HIGH crossover frequency range is 450 Hz to 9.6 kHz
[3] Low OUTPUT Controls the low frequency output level with a range of -∞to +6 dB.
[11] PHASE INVERT Switch for reversing the polarity on the Low Output. An LED indicates that the
phase is reversed.
[7] MID OUTPUT Controls the mid frequency output level with a range of - ∞to +6 dB
[17] PHASE INVERT Switch for reversing the polarity on the mid output. An led Indicates that the
phase is reversed.
[8] HIGH OUTPUT Controls the high frequency output level with a range of - ∞to +6dB
[18] PHASE INVERT Switch for reversing the polarity on the high output. An led indicates that the
phase is reversed
[13] MONO Led indicating mono mode operation.
On the back panel of the VX-02 there are markings to help you connect the source devices and amplifiers to your
To Next Page
Loading...