Need help?Do you have a question about the Skullcandy Shrapnel and is the answer not in the manual?
General| Brand | Skullcandy |
|---|---|
| Model | Shrapnel |
| Category | Speakers |
| Language | English |
Long press the power button for up to 3 seconds until the LED flashes magenta and the power on tone plays.
Long press the power button while the speaker is ON to power it down. The LED turns magenta.
When ON, press and hold the MFB for 5 seconds. LED flashes red and blue.
Short press MFB when not connected or in pairing mode to connect to a paired device.
Press volume + and – together to shift sound profiles for boosted volume or balanced sound.
Hold + and MFB for 3 seconds while ON to reset the speaker to default pairing mode.
Low battery triggers a voice notification 'please charge device'.
Plug in the micro USB cable. LED flashes magenta 2x every 3 seconds while charging.
When connected but not streaming, short press MFB to start playback. Front LED is off during playback.
When streaming music, short press MFB to pause playback.
Short press the + button to increase the volume level.
Short press the - button to decrease the volume level.
Long press the + button to skip to the next track.
Long press the - button to skip to the previous track.
Plug in the 3.5mm cable to the AUX jack. Wired playback controlled by source device.
Mic and volume + buttons are active for full call functionality when Bluetooth is enabled.
Short press MFB to answer an incoming call or hang up an active call.
Long press the center button (up to 3 seconds) to reject an incoming call.
Long press MFB (up to 3 seconds) during an active call to put it on hold.
Short press the power button during a call to mute/unmute the microphone.
Short press volume + to increase call volume, short press volume - to decrease.
Short press MFB to end current call and answer 2nd incoming call.
The device powers off automatically after 5 minutes of inactivity.
The LED turns off after 4.5 minutes of inactivity to conserve battery life.
Connects to up to two audio source devices simultaneously; only one plays at a time.
A full charge takes approximately 2 hours using the provided charger.
Choppy audio or connection problems may occur with multipoint enabled. Restore defaults to resolve.
If wired audio does not play, ensure no device is streaming and disconnect paired devices.
Place on bottom surface facing group for edge of room placement or group listening.
Place on back face for middle of group placement, creating a uniform 360 degree sound field.
To Next Page
