23 Skydio X2D - QGC Operator Manual © 2022 Skydio, Inc. All rights reserved.
Enable GPS Night Flight when flying in low-light conditions. Ostacle Avoidance is disabled, the vehicle will use GPS
sensors, instead of its vision system, to navigate. Skydio X2 will notify you in QGC if the environment is too dark to fly
using the vision navigation system and will prompt you to fly using GPS Night Flight.
Step 3 - You may be prompted to calibrate X2 before
you can fly:
• select the QGC Menu and then Vehicle Setup
• select Sensors
• select Compass
• select OK to start calibration
• rotate X2 in all orientations mirroring the
illustrations
• select OK when all of the calibrations are marked
with green
• navigate back to the Fly tab
Step 1 - Disable obstacle avoidance
Step 2 - Select the C2 button to enable infrared or
strobe light
WARNING: GPS Night Flight mode requires flying without obstacle avoidance. X2 may drift when in GPS Night Flight
mode; take extra caution when flying in this mode and do not stand near the vehicle.
Flight
GPS Night Flight
NOTE: Calibration will not be required for several weeks or even months, depending on the environment. You will be
prompted when another calibration is necessary.
To Next Page
Loading...
