Skydio X2D Home Point
Set or move a Home Point during daylight hours if you believe that landing at your launch point will give away your position. Identify a clear, level surface
where you want your X2D to land. Skydio X2D will retain its current obstacle avoidance setting while returning. Return settings persist across flights and
power cycles.
Set a Home Point:
Step 1 - Select the
Device settings menu
Step 2 - Select the Drone tab
Step 3 - Select Return Behavior
Step 4 - Select Return Type to GPS
• returning to a Home Point is not supported
using vision navigation
Step 5 - Select the
Map icon
Step 6 - Long-press a point on the map to set a Home Point or move the
existing Home Point
• if you want to return using vision navigation select Launch Point as
your return location
Step 7 - Return to the Fly screen and select the
Home icon
© 2022 Skydio, Inc. All rights reserved.
Step 8 - Select Home Point as the return location
• you will need GPS to return to a Home Point or the Controller
• if GPS signal is lost, X2D will still Return Home, however, the flight will be
less accurate
• when your drone reaches the return location, decrease altitude to
approximately 5-10 meters and manually fly to a masked landing
location, such as behind an object or in a valley
NOTE: setting a Home Point is only available during the day, you cannot set
a Home Point at night.
To Next Page
Loading...
Need help?
General
