Rear Panel
1) POWER SUPPLY INPUT JACK
Input voltage from this jack.
2) VOLTAGE SELECTOR
Select voltage which you need.
3) 1/4” OUTPUT JACKS
Connect the mixer to a receiver use cables with 1/4” plugs
4) AMP OUTPUT JACKS
Connect the mixer to a amplifier use cables.
5) ZONE OUTPUT JACKS
Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth or in a remote location.
6) RECORD OUTPUT JACKS
Connect the mixer to a second receiver or amplifier powering speakers in the DJ booth or in a remote location.
7) EFFECTS SEND/RECEIVE JACKS
Permit you to either include externally generated effects (such as a digital sampler) in the mix, or to process the mixed sound (echo
recerb, ect.)
8) LINE INPUTS
Let you connect most high-level audio source, such as CD players, tape deck, tuner or VCR.
9) INPUT SELECTOR
Set these swithches based on what is plugged into Phono/ Line input jacks.
10) MIC JACK
Microphones with a 1/4” connector can be connected to these input terminals.
11) GROUND
Ground Screw for turntables.
Specifications
Input Sensitivity/ Impedance
MIC 1-2--------------------------------------1.5mV/ 600 Ohms, bal/unbal
Phono 1-2------------------------------------3.0mV/ 50K Ohms
Line 1-8--------------------------------------150.0 mV/27K Ohms
Output Level
Amp-------------------------------------------2.0V/10K Ohms
Zone------------------------------------------2.0V/10K Ohms
Record---------------------------------------150Mv/10K Ohms
Frequency Response-----------------------20Hz-20kHz +/-3 dB
S/N Ratio ( at 1 kHz)
MIC -------------------------------------＞60 dB/ 1.5mV input
Phono ------------------------------------＞60 dB/ 3.0mV input
Line --------------------------------------＞65 dB/ 150mV input
Distortion
MIC -------------------------------------0.5%
Phono ------------------------------------0.5%
Line --------------------------------------0.5%
To Next Page
Loading...
