To Next PageTo Next Page
Need help?Do you have a question about the Skyworth 2522 and is the answer not in the manual?
Initializes the EEPROM partially before exfactory or after Chroma IC change.
Adjusts screen knob of FBT for a horizontal faintness beam line.
Adjusts focus knob of FBT for the clearest picture from monoscope pattern.
Adjusts H POSITION using PROG+/-, VOL+/- to center the pattern horizontally.
Adjusts V LINE and V SCURVE for vertical pincushion correction.
Adjusts V HEIGHT and V POSITION for vertical size and center.
Adjusts R, G, B cutoff and driver for white balance.
Adjusts grey scale signal for sub-bright setting.
Adjusts RF AGC to eliminate picture noise disturbance.
Adjusts horizontal and vertical parameters for NTSC system.
Puts receiver into warm-up line without auto shut-off.
Explains full and partial EEPROM initialization methods.
Adjusts horizontal size and pincushion for flat CRT tubes.
Menu for setting various options like TV/AV sources, decoders, etc.
Adjusts purity magnets for green field and deflection yoke for uniform green field.
Aligns red/blue dots with green dots using magnets and adjusts DY wedges.
General