Assembly:
1. Lay the carton flat on the floor and carefully cut it open.
2. Lift the carton so that the open side faces down and slide it up and off the bed.
Place the bed upside-down flat on the floor.
3. Remove and discard the plastic bag. Put together the two pieces of the bed and
align them flat on the floor.
4. Cut the zip ties, take out all the part boxes and the mattress rail, and check that
you have all the necessary parts according to the parts list.
5. For leg assembly push the screw through the triangular brace. Screw in the leg
and tighten.
6. Connect the 01-connector from the controller to the 01-plug of the power supply.
Connect the 8-wire plug of the power cable to the other jack on the switch’s power
supply.
Connect the power cable to your nearby power outlet.
7. Insert batteries into the remote control. Press the first circled button. If the motor
begins to run, unplug the power supply and turn the bed over to its right side-up
position. If the motor does not run, it needs to re-match its code.
Matching code: Press the two buttons in the circles shown and at the same time
press the little button on the side of the control box until you hear the 'didi' sound.
To Next Page
Loading...