BASE assembly
2
BEFORE YOU BEGIN
u Carefully check the contents of your base boxes. Each
component is clearly labeled with the part name and part
number.
u Decide where to put your new bed
u Make sure there’s an electric power source nearby
for use with your Firmness Control
™
System
u Assemble your bed frame if you have one
Your base should be assembled directly onto your bed frame
or on the floor. Some bed frames have slats that run from one side of the bed
to the other. If your bed frame has slats, position the slats evenly to support
the base. If your bed frame has fewer than three slats, we recommend adding
additional slats to ensure adequate support for your base.
Caution: With some styles of bed frames, the base length
may extend beyond the frame’s support legs. This situation makes it
possible for the frame to tip when significant weight is placed at the foot
of the bed. Please use caution when sitting or placing weight
on the foot of the bed when using these types of frames.
u King base
The King base consists of two Twins side by side. Complete
the assembly of one unit, assemble the second, then place side by
side on the bed frame.
If you are missing any
items listed on the
following page, please
e-mail Customer Service
at customerservice@
selectcomfort.com or
call the number on the
back cover.
TROUBLESHOOTING
For answers to some common
questions regarding your
base, see the Frequently
Asked Questions at the end
of this manual.
“ I assembled the
Sleep Number bed by
myself. My wife was in
doubt at first, but, after
sleeping one night, she
said, it was magic how well
she slept without back
pain. Now we sleep longer
and more comfortably
than with any previous
mattress we’ve owned.”
- C. Clark S., Tucson, AZ
Note: Texture and
surface appearance
may vary.
To Next Page
Loading...