Slime 50161 - Using the Inflator Safely; Ventilation and Environment; Operating Precautions; Glow Safety Signal Instructions

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A CONFINED
AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death could occur. Always
operate the inflator in a well-ventilated area free of combustible materials, gasoline, or solvent
vapors.
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle’s engine
running to achieve the optimal inflator performance. Never start a vehicle with
the inflator connected to battery terminals.
• Do not attempt to disassemble inator.
• No user serviceable parts inside.
• Keep inator out of reach of children.
• Place inator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper ination.
• DO NOT use inator continuously for more than 12 minutes. Allow unit to cool approximately 25
minutes between uses. Do not leave inator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inate.
• Soft inatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful
not to inate items beyond their capacity.
• While operating, never block the inator input or output.
WARNING
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
WHEN USING THE INFLATOR:
1. Crack and shake glow sticks to activate.
2. Insert glow sticks and leg into stand to create Glow Safety Signal.
3. Place Glow Safety Signal 100ft (approx. 40 paces) from back of your vehicle.
GLOW SAFETY SIGNAL INSTRUCTIONS