FLUSHMATE
®
INTELLI-Flush
™
AUTOMATIC FLUSHING SYSTEM
Installation Instructions
MODEL# K-100
A) Flush Module
B) Battery Pack
C) Battery Holder
D) Over-Ride Button
E) Cover Key
F) T-Wrench/Depth Gauge/
Sensor Tool
G) Screws & Anchors (2)
H) C-cell Alkaline Batteries (4)
I) AA-cell Alkaline Batteries (4)
J) On-Wall Sensor
K) In-Wall Sensor
L) Adapter 504
M) Adapter 501-B
N) Mounting Screws (8)
STEP #1
1) Remove retainer clips, (image 1), flush rod, (image 2), and handle,
(image 3). (Note: reverse threads on handle.)
COMPONENTS
Tools Required: Philips and slotted screwdriver, pliers, ruler and
1-3/4" hole saw for In-Wall
STEP #2
1) Install Over-Ride Button (D), (image 4). Identify appropriate Adapter
(L or M) if needed, (image 5).
2) Place Flush Module (A) in position over Actuator (image 6). (Actuator is the
centered white disk with Philip screw in center.) If using Adapter, (image 7)
note the positioning of the Flush Module (A) wire, (image 6 & 7).
3) Insert T-wrench/Depth Gauge/Sensor tool (F) in hole of Flush Module (A),
(image 8). Adjust Actuator by loosening set screw and turning Actuator to
proper height according to depth gauge, so that yellow ring on depth
gauge aligns with top of Flush Module (A), (image 9). Tighten set screw
on Actuator.
4) Attach the Flush Module (A) with (4) screws, (image 10). For the 501-B
Adapter (M), (8) screws are required.
STEP #3
1) Plug Over-Ride Button (D) wire into Flush Module (A), (image 11)
2) Remove cover on Battery Pack (B), (image 12). Install batteries, (image
13), noting the battery polarity (+/-) printed on pack. Reinstall cover on
Battery Pack (B), (image 14). Place Battery Pack (B) in Battery Holder (C),
(image 15). Hang Battery Holder (C) on top edge of china tank and
connect the Flush Module (A) wire into the Battery Pack (B). Slide rubber
boot over connection, (image 16). (Using the Battery Holder (C) is
optional. If there is ample space, you can place it anywhere in the tank as
long as the wire is not being stretched.)
The Sensor and Flush Module contained within this kit have been programmed to work together and should not be
switched with similar components from other kits.
Sloan FLUSHMATE • 30075 Research Drive. • New Hudson, MI 48165
Phone: (248) 446-5300, 800-533-3450, www.flushmate.com
To Next Page
General