Safety SMA Solar Technology AG
10 SMC9-11TLRP-IEN100640 Installation Guide
When designing the PV system, ensure that the values comply with the permitted operating range of
all components at all times. The free design program "Sunny Design" (www.SMA.de/en/
SunnyDesign) will assist you. The manufacturer of the PV modules must have approved the modules
for use with this Sunny Mini Central. You must also ensure that all measures recommended by the
module manufacturer for long-term maintenance of the module properties are taken (see also
Technical Information "Module Technology", in the download area of www.SMA.de/en).
Do not use the Sunny Mini Central for purposes other than those described here. Alternative uses,
modifications to the Sunny Mini Central or the installation of components not expressly recommended
or sold by SMA Solar Technology AG void the warranty claims and operation permission.
Certified Countries
The Sunny Mini Central 9000TL / 10000TL / 11000TL (with according configuration) fulfill the
requirements specified in the following standards and directives (dated: February/2010):
• VDE 0126-1-1 (02.2006)
• DK 5940 Ed. 2.2 (02.2006) (only for SMC 9000TL-10/IT / 10000TL-10/IT / 110000TL-10/IT)
• RD 1663/2000 (2000)
a)
• PPC (06.2006) (only for SMC 9000TL-10 / 10000TL-10 / 11000TL-10)
•PPDS
• C10/C11 (08.2003)
b)
• AS4777 (2005)
• IEC-utility Meeting 216
• RD 1663/661 (only for SMC 9000TLRP-10 / 10000TLRP-10 / 11000TLRP-10)
• MEA (on request)
•PEA (on request)
• Kepco guide (02.2006) (on request)
a) In the event of restrictions in certain regions, contact the SMA Serviceline.
b) Only possible when the phase voltage is 220 V.
SMA Solar Technology AG can preset special grid parameters for other countries / installation
locations according to customer request, after evaluation by SMA Solar Technology AG. You can
later make modifications yourself by changing software parameters with respective communication
products (e.g. Sunny Data Control or Sunny Explorer) (see section 5.8”Setting the Grid and Country
Parameters” (page48)). To change grid-relevant parameters, you need a personal access code - the
so-called SMA Grid Guard Code. The application form for the personal access code is located in the
download area at www.SMA.de/en, in the "Data sheet" category for each inverter.
To Next Page
Loading...
