Installing the Device SMA Solar Technology AG
20 SMC9-11TLRP-IEN100640 Installation Guide
4. Screw the inverter to the wall mounting bracket on
both sides using the screws (M6x8) provided.
Only tighten the screws hand-tight.
5. Check to ensure the inverter is firmly fastened.
6. Close the recessed grips with the fan grills
provided. The air grills are marked "rechts/right"
and "links/left" on the interior for proper
assignment.
The air grills prevent dirt and insects from entering
the device and, if necessary, can be reordered from
SMA Solar Technology AG (see section
12”Accessories” (page88)).
Optional Theft Protection
To protect the inverter against theft, the rear
panel can be secured to the wall at the bottom
using 2 single-use bolts.
The other two holes are spares.
To Next Page
Loading...
